RFID coil antennas

Priority 1 Design carry a stock of these RFID coil antennas. Our RFID coil antennas have been designed by us
specifically for our RFID readers and transponders but can easily be used by hobbyists and professionals to
create their own RFID designs.

Learn about RFID design in RFID basics.

RFIDCOIL-22A View Prices	RFID coil Specifications: Winding Type   Unsupported Bondable magnet wire Inductance at 125Khz   2.8 mH   nominal Coil Resistance   53.8 ohms     +/-  1 ohm Wire diameter   0.09 mm Coil inside diameter   19 mm Coil outside diameter    21.8 mm  +/- 0.2mm Coil Width   2.5 mm +/-  0.3mm This coil is used as our main antenna in our mRFID reader modules. View an example rfid reader circuit using this coil antenna.
RFIDCOIL-49A View Prices	RFID coil Specifications: Winding Type   Unsupported Bondable magnet wire Inductance at 125Khz   2.8 mH   nominal Coil Resistance   63 ohms     +/-  1 ohm Wire diameter   0.09 mm Coil inside diameter   46 mm +/- 0.5mm Coil outside diameter    49.0 mm  +/- 0.5mm Coil Width   1.5 mm +/-  0.2mm This coil was designed to give our rfid readers longer read range. Typical read distances based on our example circuit are 8cm for keytags and 10cm for rfid cards. View an example rfid reader circuit using this coil antenna.
RFIDCOIL-160A View Prices	RFID coil Specifications: Winding Type   Unsupported Bondable magnet wire Inductance at 125Khz   2.7 mH   nominal Coil Resistance   19 ohms     +/-  1 ohm Wire diameter   0.2 mm Coil inside diameter   160 mm +/- 0.5mm Coil outside diameter    163.3 mm  +/- 0.5mm Coil Width   2.3 mm +/-  0.4mm This coil was created for our RFIDLOG series of rfid data loggers. Its large 16cm diameter allows for greater read range than a smaller antenna will allow. Its also suitable for use with our RFIDRW-E series of readers with only a slight addition to the tuning capacitor. View an example rfid reader circuit using this coil antenna.
We also stock:  RFID Reader Modules  RFID keytags  RFID Proximity cards  RFID reader IC's